If you want the current S to bind to J, just change the S in the code to J. For the analog goto line 69 and start there, do not change the dPadNon = 0 but you can alter wasd. You can also alter the code so any digital pinout does any key stroke. If you copied mine, this should work, but if you used a different pin, just relable that pin. Over the time, I have changed my binds so you need to make sure in the code at lines 84-96 you have the correct pins. make sure you wire them to an analog pinout. the circle with the X/Y are analog controls. In the drawing you can see what i had going to each key. you can also test for continuity with a multimeter.Īfter you have all working switches, you will want to wire up the switches. Press the button if the light goes on, its working. i did this one at a time and since they use the same ground i just move the +. 179 Dislike Share BeefNorris 81 subscribers Here is a guide on How to Set up your azeron Classic Gaming Keypad With World of Warcraft If you Do enjoy the Vid Please Smash A like and. Next test your buttons, Easiest thing i did was wire up a LED with a resistor and put each switch between them. I just opened up textedit (wordpad) to do this, take a ground connection and test it against the pins from the simple drawing i made./ Only test the ones that have a letter beside them. Test the buttons against the pins to see if they register. Upload the code and plug the board into a computer. Then select board "leonardo" it wont compile if you use a different one. Install The arduino IDE here make sure you have the right drivers, im pretty sure the IDE has them.
Once you have them all setup, place the covers on and put your m2 nuts on the bolts.Īlso you will want to braide your cable when its all done, be careful not to pull the wire off the solder joint. I noticed i needed to sand down near the hinge to allow more room between the buttons, It will most likely happen on the rest as well, so if you need to alter 1 button, might as well do them all like that. ( its really just hinge and doesnt need to fill the entire hole) You may get a few that stick, which means you will have to take it apart and sand/.file down parts of the button. I found that with m3 screws they were way too tight and just used tiny m2 screws.
Once you have it all in place, test the buttons that they switches make contact. you will have to take the switches out 1st to alter anything. (i did) just remember the switches are going to hold the buttons in place, you will not be able to remove the buttons when all 3 switches are in place.
There isnt a lot of room, you may need to sand/shave a bit off the sides. Once the buttons are in, you will need to insert the switches. then place each button in its place, ( no the switch) you might want to get a long m3 screw to hold it there. but should come off early, just try not to damage the switch body. I had to learn the hard way how to do this.ġst thing you need to do is remove all the metal tabs from teh switches.
0 kommentar(er)
